Operation: stop and start the timing function through the push device in the lower left corner around 8 o 'clock. At 10 o 'clock, reset the pointer by pressing the other hand in the upper left corner.
richard mille bubba watson Gravity indicator
This mechanism aims to visually display the G value accumulated by the watch wearer during the rapid deceleration. A pointer and scale below 12 indicates whether the deceleration is slight (green area) or severe (red area).
Objective function
Like a car's gearbox, the function indicator lets you see the windings, neutral and manual positions as the roof is pulled out. Each position is indicated by hand at 4 o 'clock, showing the following functions :W(winding) -n (neutral) -h (manual setting).
Free sprung equilibrium with variable inertia
This type of balance wheel represents the acme of innovation, ensuring higher reliability in the event of impact, as well as in the assembly and disassembly process of the movement, resulting in better timing results over time. This indicator is eliminated, thus allowing for more accurate and repeatable adjustment using 4 set screws.
Rotate the cylinder rapidly (6 hours per revolution instead of 7.5 hours)
This kind of barrel has the following advantages:
- periodic adhesion of main spring is significantly reduced,
replica swiss watches thus improving performance.
- provides excellent main spring increment curve with ideal power reserve/performance and regularity ratio.
Modular time setting mechanism is installed behind the case
In terms of service life and maintenance, it has the following advantages:
-
buy replicas watch since the components are installed outside the movement, it is possible to change the time setting of the components without affecting the integrity of the floor to prevent possible defects or during maintenance,
- there is no need to remove the pointer and dial to install and remove the module from the back.
5 class titanium spline screw for bridge
This allows better control of the torque applied to the screw during assembly. Therefore, these screws are not affected by physical operation, are well assembled or disassembled and aged.
The extreme movement is over
Professional watchmaking techniques can be found on the rm50-01 caliber watch. All cases are hand-made, including wire-drawing, polishing, satin polishing and soft polishing. The complex shapes of tourbillon and barrel Bridges in fine sandblasted stainless steel are typical examples where the visible and invisible areas are completely soft polished. Then manual bevel and rhodium-plated front teeth are cut. All kinds of yoke are straight lines, both sides of the grinding soft. This series of finished products also optimizes the technical functions of the chronograph.
movement
Caliber rm50-01:
replica watches uk manual winding tourbillon motion, g sensor, hour, minute and timer, central second and 30 minute counter at 9 o 'clock. Power reserve: about 70 hours (±10%)
- sport size :32.00 x 36.70 mm
- thickness :7.53 mm
- tourbillon diameter :12.30 mm
- diameter of balance wheel: 11.50mm
Jewelry: 35
- lift Angle 53°
-- balance wheel :Glucydur, 2 weapon and 4 setting screw, inertia 10 mg cm -- frequency :21600 VPH (3 Hz) -- central bridge aluminum -- spring: Elgin steel, nivolox ® -- impact protection: ELASTOR ELASTOR 160 B28 drum shaft free of nickel chronifer (DIN x 46 Cr 13 + S), features: stainless steel -- non-magnetic
Autor